Home > Power Supplies >

730W 110-240V AC Power Supply for Dell PowerEdge 2600 - Refurbished

Dell 730W Power Supply for PowerEdge 2600 C1297 Refurbished
Dell 730W Power Supply for PowerEdge 2600

730W Dell Power Supply
Our Price: $69.49
Product Condition: Refurbished (functions like new)
Stock Availability: out of stock
Databug Warranty: 6 Months

Availability:: Usually Ships in 24 Hours

Overview Features

Dell 730W 110-240V AC Power Supply for PowerEdge 2600 - Refurbished

The Dell brand Power Supply provides reliable power for your mission-critical applications. This product has been tested
and validated on select Dell systems.

PowerEdge 2600 can take up to 2 hot-plug, 730-W power supplies with optional 1 + 1 redundant configuration.
The power
supplies are hot-pluggable. The system requires one power supply to be installed for the system to operate normally. The
is in the redundant mode when two power supplies are installed. Remove and replace only one power supply at a
time in a system that is powered on.

Illustration 3 shows the 2 power cable connectors on the server (1 is covered with a cap)
Both must be plugged in to a AC power source (wall outlet / UPS) when 2 PSU is installed

If a single power supply is installed, the system must be shut down and the power cables disconnected from the power
receptacle. If there are two power supplies installed, the system is in the redundant mode and the faulty power supply
can be removed and
replaced with the system is powered on.

This PS unit was technician tested as it was previously owned. In terms of functions and efficiency, no difference was
between a new PS module and this one. The PS unit may have light scratches from sliding out of the slot but
those are not visible once plugged into the server.
Technical Specs
ProductPower Supply Unit for Server
Output Wattage730W Max.
Redundancy SupportYes (When used in pair)
Input Power Range110-240 VAC, 50/60 Hz
Cooling FanDual Internal Fans
Heat Dissipation3100 BTU/hr
CompatibilityPowerEdge 2600 and PowerVault 770N

Maximum inrush current- under typical line conditions and over the entire system ambient
operating range, the inrush current may reach 55 A per power supply for 10 ms or less.

Share your knowledge of this product. Be the first to write a review »